1. Power Focus 6000
2. Configuration
3. Working with the Controller Tab
4. Synchronized Tightening
5. Synchronized tightening Signals
6. Output Signals: Sub-signals
7. Channel Hardware Status - 81: Sub-signals
8. Tool Any Hardware Error

Tool Any Hardware Error

This sub-signal is set whenever a tool hardware error is detected. This can be any of Tool Temp High, Motortune Needed, Tool Cable Invalid, Tool Disconnected, Torque Transducer Error or Tool Hardware Error.

Name in SoftPLC: CHANNEL_HW_STATUS_TOOL_ANY_HARDWARE_ERROR