1. I/O Hub Software
2. Introduction
3. System Overview
4. Home Menu - I/O Hub Web Interface

Home Menu - I/O Hub Web Interface

The I/O Hub Web Interface consists of 3 parts.

Controller

This section is used to set the IP address for the controller.

Device

This section is used to set the device ID and serial number for the I/O Hub device. This helps to keep track of the devices, if multiple ones are connected to the same controller. When connected to Power Focus 6000, the I/O Hub device ID and serial number is displayed on the virtual station page in the Power Focus 6000.

Links

This section provides a link to the Internal Web Pages. The Internal Web Pages are accessed through the I/O Hub Web Interface. It is recommended to contact your local Atlas Copco Service Technician or Sales Representative if any changes are wanted there. Note that changing these setting may permanently affect the functionality of the I/O Hub 8-PS. You are solely responsible for any settings changes implemented without the authorized support from Atlas Copco.