Process Page

The Process page shows the status of the current running tightening process. Optionally, the tightening process can also be started from this page.

Usually, the Process page guides the operator.
In the Process page, the operator can track the tool position with the crosshair on the workpiece image; thus, it is possible to follow the progress.

The Process page is organized with the following layout:

A header: with the process status
Content area: with the main image on the left side and the process information panel on the right side.

Header elements

Process: the current workpiece id (when the process is running)

VIN: the last received VIN

Header buttons

The workplace settings can make the following buttons visible in the header (the buttons can be selected in the HMI tab in the settings of the workplace).

RESET PROCESSCONTROL: resets all the processes.
FINISH PROCESS: completes the current process/workpiece in the workplace.
SKIP POSITION: skips the current tightening position (only if the position is enabled)

Content Area elements

Image part on the left side:

Process image with overlaid points for positions/bolts
Process image of the active level or workpiece is shown

Process State Messages

Centered error or info text is shown when required data is missing.

No running process
Missing workplace (no workplace is created)
Missing tool (no tool is created)
Missing tool assignment in workplace
Missing process

Process Information on the right side panel:

Workpiece ID
Last result table (Status, Torque, Angle) for all the tools that are assigned to the workplace.
Tightening tables (when referencing is not enabled, see No Referencing Process Page elements below)
Referencing positions table (when referencing is enabled, see Referencing Process Page elements below).

Last result table

For each tool, the panel shows:

Status of the result.
Torque value with unit. The unit can be selected¹.
Angle value.

If there are multi-spindles their results are shown in this table.

No Referencing Process Page elements

Tightening tables

When referencing is not enabled, the panel shows:

Tightening groups with ID and State
Tightening positions with ID, State and number of Tries

For information about position colors during tightening without referencing, refer to the Process Page Tightening Colors chapter.

Referencing Process Page elements

Referencing Positions table

When referencing is enabled the panel lists up to three referencing positions. The table contains the following:

Position ID
Event type (tighten or acknowledge)
State (pending, in progress, done)

For information about position colors during tightening with referencing, refer to the Process Page Referencing Colors chapter.