Configuring the Connnection Types

Configuring OpenProtocol

In Virtual Station, select Protocols.
Turn on Open Protocol.
Enter the Open Protocol Port.
The standard port is 4545.

Configuring ASDK

Prerequisites:

The controller software system API to communicate with the tightening controller.
An ILG embedded license per tool.

Set the IP to 127.0.0.1 in ILG.

Configuring ASDK remote

Prerequisites:

A custom-made protocol to communicate with the tightening controller.
ILG embedded license.
If port number 0 is used in ILG the name of the Virtual Station must be the same as the name of the tool in ILG (note that the ILG tool cannot be changed after creation).

Set the IP in ILG to the same IP address as the one on the controller.

By using port number 0 and not the OpenProtocol port the following function will not be available:

VIN number will not be received from the controller to ILG.

For full support OpenProtocol should also be configured and running on the controller, and the port number in ILG should be the same as the OpenProtocol port number that is configured on the controller.