Reteach Operations

Procedure for Reteach for one position

In the Configuration mode, on the Tightening Positions page, in the Tightening Positions list select an existing position.
Put the tool in the necessary tightening position. Then, at the top of the Tightening Positions page, select the Reteach button.
The position coordinates change according to the current position of the tool.

Procedure for Reteach for multiple positions

In the Configuration mode, on the Tightening Positions page, in the Tightening Positions list select an existing workpiece/group.
Put the tool in the necessary tightening position. Then, at the top of the Tightening Positions page, select the Reteach button.
The position coordinates change according to the current position of the tool.
Put the tool in the necessary tightening position. Then, press the tool trigger shortly.
After each trigger signal, a message appears.
Confirm the information on the successful teaching and move on to the next tightening position. Repeat this step for all the necessary tightening positions.
A possible warning about tool being disabled is not important as the teaching process does not require tightening.