Teaching Operations

In the Configuration mode, on the Tightening Positions page, select a row for a workpiece in the Positions table to teach positions in the workpiece.

Alternatively, if no workpiece is selected a new workpiece will be created with new taught positions.

At the top of the Tightening Positions page, select the Teaching button. The Teaching pop-up window opens.

Put the tool in the necessary tightening position. Then, press the tool trigger shortly.
After each trigger signal, a message appears.
Confirm the information on the successful teaching and move on to the next tightening position. Repeat this step for all the necessary tightening positions.

A possible warning about tool being disabled is not important as the teaching process does not require tightening.

At the top of the Tightening Positions page, select the Teaching button to stop the Teaching process.

Select the OK button to finish the process.