EHMI Start-up Progress Indications

The information in this section is only valid for tools running IxB Software from version 3.7 and onwards.

When starting the tool, the EHMI will indicate if a software update is in progress by displaying the following messages:

NOTICE

Do NOT pull the battery from the tool during the software update procedure. The tool can get damaged.

A module is a subsystem or component which is part of the IxB tool, and updated through the IxB Software.

Module (as shown on the display)	Description
MRT	Main board
MCB	Power module
FTS	Front transducer
EHMI	Extended HMI
BHMI	Basic HMI

If an error occurs during the software update, the following message will be displayed:

The errorId corresponds to error messages, as follows:

Id	Error Message	Description	Suggested Action
0	None	-	-
1	Module board info not valid	Module produced with incorrect data	Replace module
2	Module device information not valid	Module produced with incorrect data	Replace module
3	Module file corrupt	File system is corrupt	Replace IAM
4	Module firmware not compatible with hardware	Software not compatible with hardware	Update to later release
5	Module firmware file not found	File system is corrupt	Replace IAM
6	Error when reading module firmware file	File system is corrupt	Replace IAM
7	Communication timeout when trying to update module	Damage on the connector/cable or the module	Replace IAM
8	Error when receiving data from module	Damage on the connector/cable or the module	Service the tool
9	Unexpected reply from module	Damage on the connector/cable or the module	Service the tool
10	Module unreachable	Damage on the connector/cable or the module	Service the tool
11	Error when transmitting data to module	Damage on the connector/cable or the module	Service the tool
12	System on backup battery	System is running on backup battery	Restart tool - do not remove battery or power adapter until update is complete