Installing the unit
Install the MWR-KIT on a vertical surface (for example a wall) or an horizontal surface (for example a table) in one of the following configurations:
A | Inward brackets configuration | B | Outward brackets configuration |
Refer to the following instructions to install the brackets in the inward or outward configuration, making sure to respect the order of the screws, brackets, and seals as shown in the image below:
From the MWR-KIT, remove the four caps where the brackets have to be installed (bottom and top sides for the inward configuration, or lateral sides for the outward configuration).
Using a Torx T10 screwdriver, remove the four M3x10 screws from the MWR-KIT.
Insert the M3x18 screw provided in the installation kit in the designated bracket hole.
Slide the 4.5 mm seal over the screw, so that the screw and the bracket are locked together.
Insert the screw in one of the screw holes on the MWR-KIT sides and fasten it using a Torx T10 screwdriver.
Repeat the procedure from step 3 to 5 to install all brackets.
