Uploading the MWR firmware
The maximum number of tool firmware versions that can be stored on the SD card of the MWR-KIT is five.
Access the MWR-KIT web GUI.
From the main menu on the left side of the MWR-KIT page, select Scan.
In the Scan section of the Wrench scan page, select the checkbox of the region where to scan the available wrenches.
Then, click on the Start Scan button.
In the upper-left part of the MWR-KIT page, the status changes from the Active mode to the Configuration mode and the progress of the Scanning process is displayed in percentage.
The MWR detected during the Scanning process are displayed in the Tools section of the Wrench scan page.
In the Tools section, click on the Configure button.
In the Remote firmware update section, click on the Upload new button.
In the Upload MWR firmware dialog box, click on the Open (.emh) button and select the .emh file to upload.
Then, click on the Open (.dat) button and select the .dat file to upload.
Upload both the .emh file and the .dat file. Both files must belong to the same firmware release.
When the two files are selected, click on the Upload button.
The MWR firmware is saved on the SD card of the MWR-KIT.
To exit the Configuration mode and return to the Active mode, click on the Reset button placed in the upper left-part of the page.
