Prerequisites

Many events in the operating environment may affect the tightening process and shall require a validation of results. In compliance with applicable standards and/or regulations, we hereby require to check the installed torque after any event that can influence the tightening result. Examples of such events include but are not limited to:

initial installation of the tooling system
change of part batch, bolt, screw batch, tool, software, configuration or environment
change of air- or electrical connections
change in line ergonomics, process, quality procedures or practices
changing of operator
any other change that influences the result of the tightening process

The check should:

ensure that the joint conditions have not changed due to events of influence
be done after initial installation, maintenance or repair of the equipment
occur at least once per shift or at another suitable frequency

Anyone interested in learning more can benefit from reading this manual and other QA Supervisor documentation.

Before starting the application ensure that:

the QA Supervisor server application is installed
controllers are configured to communicate with the QA Supervisor server application

Browser requirements

Google Chrome 112
Microsoft Edge 112 (chromium)
Mozilla Firefox 112

The browser zoom must always be set to 100% while using the application.

TLS versions prior to 1.2 are no longer supported.