FCC and ISED Compliance Statement
This device complies with Part 15 of the FCC Rules. Any changes or modifications not expressly approved by the manufacturer could void the user´s authority to operate this device.
Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
The device is only in compliance if no changes or modifications are made to the device.
The device is in compliance with the requirement for RF exposure in the US with 20cm separation distance between the user and the device. The antenna is fixed to the device and no change in antenna or fixation of the antenna is acceptable and such modification is considered to violate the Compliance Statement.
FCC Responsible party:
Name: Rodney Hill
Position: Product Marketing Manager
Address: 3301 Cross Creek Parkway
MI 483 26 Auburn Hills
United States
Mobile: +1 919 272 7837
Email: rodney.hill@us.atlascopco.com
FCC ID: 2AIPFMTR
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
ISED Compliance Statement:
This device complies with: CAN ICES-1(A)/NMB-1(A)
(English) This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
(French) Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage;
(2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
(English) This equipment complies with RSS102’s radiation exposure limits set forth for an uncontrolled environment under the following conditions:
(1) This equipment should be installed and operated such that a minimum separation distance of 20cm is maintained between the radiator (antenna) and user’s/nearby person’s body at all times.
(2) This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
(French) Cet équipement est conforme aux limites d’expositions de la CNR102 applicables pour un environnement non contrôlé aux conditions suivantes:
1) Cet équipement devra être installé et fonctionner de telle manière qu’une distance minimale de séparation de 20cm soit maintenue entre la partie rayonnante (l’antenne) et l’utilisateur / les personnes à proximité à tout moment.
2) Cet émetteur ne doit pas être co-localisé ou opérer en conjonction avec toute autre antenne ou émetteur.
Company Name: Woodstar Inc
Contact Name: Stephane Mercure
Street Address: 46 chemin du Faisan, Saint Sauveur, Quebec, Canada, J0R R1R
Telephone No: 514-667-6868
Fax No: 514-6676870
Email: ms@woodstar.ca
IC_ID: 21556-MTR
