Mounting instructions

  1. Remove the angle head.

  2. Remove the circlip and the cap nut.

  3. Remove the shaft and the plastic protection.

  1. Screw on the cutting tool.

  1. Cut the insulation. The flex cable is protected under a shield.

  1. Assemble the accessory. Start by fitting the lower half in the correct position.

  1. Fold the upper half in the correct position and tighten the 2 screws (1.8 Nm).

  2. Assemble the new shorter cap nut and the circlip on the angle head.

  3. Assemble the shaft and the angle head on the tool. Tighten the cap nut to specified torque.