ST Selector

The ST selector is a tool accessory. It is installed on the tool and connected to the tool accessory bus. It has a small display, two input buttons and output LEDs.

Display

The display shows one information at a time and has four different pages that can be configured to display different preset items on every page.

Parameter

Description

Default Value

Page 1

Select the message to be displayed from the list:.

  • Final torque

  • Final angle

  • Batch count

  • Remaining batch

  • Generic IO 1

  • Generic IO 2

  • Generic IO 3

  • Generic IO 4

  • Generic IO 5

  • Generic IO 6

  • Generic IO 7

  • Generic IO 8

  • Generic IO 9

  • Generic IO 10

  • Selected tightening program

  • Selected batch sequence id

  • Target torque

  • Target/Final torque

None

Page 2

Page 3

page 4

Switch time

Parameter

Description

Default Value

Switch time

Select the time to display one message before the next message is displayed.

1 s

Buttons

The two buttons can be configured to act upon the displayed information and used to step through listed items.

Parameter

Description

Default Value

Left button

Select one action from the shortcut menu. The available parameter values are: Off, Take previous and Take next

Take previous

Right button

Select one action from the shortcut menu. The available parameter values are: Off, Take previous and Take next

Take next

Status LEDs

The status LEDs can be activated or deactivated.

Parameter

Description

Default Value

Show result LEDs

The parameter values are On and Off

On

Show extra LEDs

The parameter values are On and Off

On

The result LEDs are red, green and yellow, and show the same information as the main tool LEDs.

The two extra LEDs can show Batch OK and Batch sequence OK. Both these LEDs are turned off at the next tightening.