Installing the ILS Target

Remove the four T8 screws so that the two holders underneath become loose.

Fasten the two holders onto the tool.

Mount the ILS Target onto the holders.

Tighten the four T8 screws.

Loosen the two T10 screws from the cap and remove the cap.

Remove the cover tag.

Insert the ILS Matrix.

Make sure to insert the side with the clipped corners first.

Be careful not to scratch the surface of the ILS Matrix. It can affect the performance of the positioning.

Put the cap back and tighten the two T10 screws.

Only applicable to TBP tools: Put on the rubber cover.