Assembling the frontal support

The MTRwrench cradle is delivered with cradle support for 85/200 Nm (4027004805) included in the box.

The MTRwrench cradle required support to hold the MTRwrench in the correct position during charging.

WARNING

Unstable Tool During Charging

The wrench could flip and battery cannot be charged properly.

  • Do not charge the MTRwrench 85/200 Nm without the support.

 

 

  1. Remove the screws (2) and the support (1).

    • The support is not to be used for wrenches of 25 Nm and 50 Nm capacity.

    • The support must be used with wrenches of 85 Nm and 200 Nm capacity.

  2. Install the support (1) with the screws (2).

  3. Loosen the screws (3) to adjust the position of the support (1).

  4. Adjust the position so that the support (1) is in contact with wrench tube.

  5. Tighten the screws (3) and the support (1).