Cleaning the coarse air filter
WARNINGRisk of severe injury
Air under pressure can cause injury.
Always shut off the air supply when not in use or before any adjustments.
Drain the hose of air pressure and disconnect the tool from air supply when not in use or before any adjustments.
Always use the correct hose size and air pressure for the tool.
Required tools:
Vice
Torque wrench
Wrench (3/8”)
Blow gun
Spare parts: At 1 000 hours service the filter shall be replaced.
Position the tool in a vice. Lock the throttle lever to the throttle handle with tape.
Disconnect the air adapter from the handle using a wrench.
Disassemble the 360-outlet adapter from the handle.
Disassemble the screw cap from the handle using a wrench.
Clean the coarse air filter using a blow gun.
Replace the coarse air filter if any damage or malfunction is detected.
Assemble the cleaned or new course air filter with the o-ring in the screw cap.
Fit the screw cap in the handle and tighten using a wrench to recommended torque.
Assemble the 360-outlet adapter with the o-ring to the handle.
Tighten the air adapter with the spring to the screw cap using a wrench to recommended torque.
Remove the tape.
