Opening / Closing the Panel PC

Remove the 4 screws on the backside of the Panel PC.

Carefully lift the back unit of the Panel PC to a maximum 25° to access the internal cabling at the front.

Be careful not to damage USB.

Carefully disconnect all cables from the front unit of the panel PC before removing any other parts.

The connectors, and especially the display connectors, must be handled with care to prevent damage.

Put the front unit aside with care not to damage the glass surface.

Assemble in reverse order.

Make sure that the yellow gasket is in correct position before you put the front back in position.

Put all screws back in position and tighten them lightly.

Then tighten them all to a torque of 1.4 Nm.

By opening the housing of Assembly Control Thin (Panel PC), all warranty claims are lost.