Changing the Guide Bearing and Inserts
Select the correct combination of milling head, guide bearing and inserts accarding to table in section Configuration options.
Required tools:
Torx key T15
Press the lock mechanism and use the torx key to loosen the guide bearing.
Remove the guide bearing.
Press the lock mechanism and use the torx key to loosen the inserts.
Remove all inserts if you want to replace them with a new set of inserts.
If the edge of the inserts is blunt, keep the existing inserts and rotate the inserts to a side with a sharp edge.
Press the lock mechanism and use a torx key to tighten the inserts.
Place the guide bearing into position.
Press the lock mechanism and use a torx key to tighten the guide bearing.