1. ETP ST101-200-F-HAD
2. Installation
3. Installation Requirements
4. Reaction bar
5. 2 Defining the bending point of the reaction bar, Fig. A

2 Defining the bending point of the reaction bar, Fig. A

Use a piece of paper to make the drawing and measurements. Use a ruler and a protractor for accurate drawings.

• Determine the minimum angle a, according to the table.

• Determine the contact point (K) of the reaction bar. Make it as far away from the tool centre line as possible.

• Measure the resulting angle a, and make sure it is greater than the table entry for the selected torque.