Digital Input Step

The digital input step will pause the ongoing tightening until a specific signal has been received by the controller.

This is not a hold step. Tool will pause the tightening and will not hold the torque.

A

Pause tightening and wait for signal

B

Resume tightening

C

Signal high

D

Signal low

Parameter

Description

Input signal

External monitored 1-8

Signal flank

  • Positive flank – Signal will go from low to high

  • Negative flank – Signal will go from high to low

  • Any flank – Signal will go from one flank to the other

  • High level – Signal will be high

  • Low level – Signal will be low

Max. step time

Setting a maximum time for the step. If exceeded, the controller will display an error message.

Vacuum enabled

Digital output to switch on an external vacuum pump.