Set up a new Pset

The basic workflow when programming a Pset in ToolsTalk MT consists of the following steps:

  1. Open the Psets window.

  2. Click the Add button.

  3. Select a Pset number and a Pset name.

    Click the OK button.

    The Pset will appear in the Pset list.

  4. Doubleclick on the Pset to open the Pset window or mark and click Open.

  5. Enter general settings.

  6. Add the Pset steps. This is the most common setup for a standard screw tightening application:

    • Thread engagement step

    • Angle step

    • Torque step.

  7. Press the Expand all button or doubleclick on a step.

  8. Set step type for each step and set the step parameters.

  9. Click the Save button to save the settings to the controller.