Connect controller to ToolsNet

Static mode

  1. Connect the controller to the factory network via Ethernet.

  2. Set Network mode to Static in Controller settings > Configuration > Network.

  3. Set IP-address, subnet mask, gateway to the controller.

  4. Enable ToolsNet.

  5. Set IP-address of ToolsNet server.

  6. Set ToolsNet port, 6700 is the standard port for all MT devices.

  7. Select if the controller should synchronize time with ToolsNet.

DHCP mode

  1. Connect the controller to the factory network via Ethernet.

  2. Set Network mode to DHCP in Controller settings > Configuration > Network.

  3. Enable ToolsNet.

  4. Set IP-address of ToolsNet server.

  5. Set ToolsNet port, 6700 is the standard port for all MT devices.

  6. Select if the controller should synchronize time with ToolsNet.