Revision History

Search

Release Number

Revision Date

Revision Description

item

item

none

3.16

03/2026

NEW content

3.14

02/2026

UPDATED content

  • Tool Information

  • Tool Health

  • Front End configuration

  • Radio Equipment Directive (EU) 2014/53 (RED) and Commission Delegated Regulation (EU 2022/30) supplementing RED

3.13

09/2024

NEW content

  • Configuration of HTTPS

  • Configuring HTTPS

  • Zero Offset and Shunt

  • Transducer Information

  • Certificates

UPDATED content

  • Calibrating the Tool

  • Event Codes

  • Start Source

  • List of Third-Party Licenses

  • Configuration of the Multiple Transducers

  • Tool Diagnostics

  • TC - Torque Calibration

  • DT – Tighten to DynaTork

  • Configuring the ToolsTalk Connection

  • Configuring the ToolsNet Connection

  • Configuring a Source Tightening

3.11

01/2024

UPDATED content

  • Event Codes

  • NOK Results List

  • Configuration of the Tool LEDs

  • Pairing a Wireless Tool to a Controller replaces the section WLAN and Bluetooth for Wireless Tools.

  • General Virtual Station information about enable and disable loosening/tightening changed. Additional information to General Virtual Station updated: Configuring Live Result Presentation Settings and Configuring the storage of Final Torque and Trace

  • Stepsync replaced with either controller or Synchronized tightening in the whole User guide.

REMOVED content

  • The section Configuration of the Wireless Settings removed from Working with the Settings Tab.

3.10

06/2023

NEW content

  • Troubleshooting Matrix added in Troubleshooting and Service

UPDATED content

  • Exporting "Logs from Connected Tools" QST-M added

  • PrT - Prevailing Torque

  • Event Codes Battery status added

  • Tool Diagnostics Diagnostic test added

  • Configuring Protocols Window in a Virtual Station Communication timeout value added

3.9

01/2023

NEW content

  • Configuration > Working with the Tool Tab > Tool Diagnostics

  • Configuration > Working with the Tool Tab > Zero Position

UPDATED content

  • Configuration > Working with the Tightening Tab > Multistep Programs > Step Monitors

  • Configuration > Working with the Configurations Tab > General Virtual Station

3.8

06/2022

NEW content

  • Configuration > Working with the Controller Tab > Export/Import > Exporting "System Logs and Information"

UPDATED content

  • Reference > Input Signals

  • Configuration > Working with the controller tab > StepSync > StepSync Signals > Input Signals: Sub-signals

  • Reference > Output Signals

3.7

01/2022

NEW content:

  • Configurations Tab > Tool Configuration > Configuration of the Open End

  • Settings Tab > Configuration of the Protocol > Configuring the Remote Logging Connection

  • Settings Tab > Configuration of the Extended Logging

  • Settings Tab > Configuration of the Extended Logging > Configuring the Log Groups

UPDATED content:

  • Multistep Programs > Step Monitors (C - Current)

  • Multistep Programs > Settings for a Multistep Program (Program Monitor - Time, Program Restriction - Angle, Program Restriction - Time)

  • Multistep Programs > Step Restrictions (C - Current)

  • Event Codes list

  • Input Signals - Power Focus XC

  • Output Signals - Power Focus XC

3.6

06/2021

First official release of the user guide for Power Focus XC.

Relevant Information