1. ETV STR31-15-10
2. Installation
3. Installation Instructions
4. Fixtures for Tensor angle type models
5. Customer-developed fixturing equipment
6. For torque less than 100 Nm

For torque less than 100 Nm

• The clamping area shall be as large as possible

Avoid clamping on the angle head and cap nut.

STB/ST/ES/SL/SR equipment:

• Fit the clamp around the motor.

• Clamp on the sides of the tool.

STR equipment:

• Preferably, choose a solution that Atlas Copco provides.

• If not possible, fit the clamp around the motor. Cover the inside of the clamp using a rubber cloth to protect the marking plates and plastic cover of the motor.

• Clamp on the top and bottom of the tool.

• Keep the clamping load as low as possible.