Attaching and balancing the tool when mounted on a bench
Do not use SMC 200 and SMC 300 with a bench stand.
-
Adjust the height of the arm relative to the work piece. It is recommended to mount the arm attachment at the same height as where the torque is applied.
-
Attach the tool holder to the tool.
-
Attach the tool holder to the arm. Install the screw and tighten it:
-
SMC 12/25 (M6) - 10 Nm
-
SMC 50/100 (M8) - 24 Nm
-
-
Install the set screw on the tool holder and tighten it to 2.5 Nm.
-
Balance the tool with the balancer.