Installing Accessories
The disassemble of the tool or the accessories must only be performed by qualified maintenance personnel.
Make sure the battery is disconnected before starting to disassemble.
Required tools:
Adjustable wrench
Screwdriver
Loosen the front cap nut, using an adjustable wrench.
Remove the 4 screws on the two half-rings behind the cap nut. Remove the two half-rings.
Connect the flex cable of the accessory, to the USB port.
The USB connector can be damaged if not connected correctly. The USB connector must be connected so that the flex cable is folded over itself and not twisted.
Place the accessory, with the built in upper half ring, on the tool.
Fasten the accessory with the lower half ring, using the 4 screws included in the accessory box. Tighten with a maximum torque of 1.2 Nm.
Tighten the front cap nut with a maximum torque of 80 Nm, using an adjustable wrench.
