1. Industrial Location Guidance (ILG)
2. Operation
3. Standard Process Sequence
4. Working with a Workpiece
5. Retry

Retry

The Operator can repeat the tightening on a position previously tightened with a NOK result, depending on the setting of the given group.
Usually, the operator must first loosen the tightening position. In a given workpiece model, it is possible to set a Retries limit value per tightening position.

To perform the retry, the operator must set the tightening tool direction to tightening.

When the operator gets to the allowed numbers of retries, it is possible to bypass this position - if the ILG system receives a previously configured bypass signal - and proceed with further tightenings. Alternatively, the ILG system can declare the whole workpiece NOK and finish working on it.