Installing Accessories

Preparations

If the tool is equipped with a rubber cover, with no hole for the accessory, do the following:

Remove the rubber cover from the tool. Cut out a hole for the accessory and then put the rubber cover back onto the tool.

Mounting the Accessory

The ports are covered by a lid. To remove the lid, use a 1.3 mm Allen key and turn clockwise.
Remove the lid and the screw.
Loosen the two T10 screws on the accessory.
Connect the flex cable of the accessory, to the USB port.
The USB connector can be damaged if not connected correctly. The USB connector must be connected so that the flex cable is folded over itself and not twisted.
Mount the accessory onto the tool and tighten the two T10 screws.