Removing the EV cover

Do not remove the EV cover from the tool until you must remove it for tool servicing.

  1. Remove the four rubber rings from the EV cover.

  2. Remove the rubber profile from the insulated display frame.

  3. Remove the insulated frame and the insulated button cover from the display.

  4. Separate and remove the two halves of the EV cover and the eject pin from the STRwrench.

STRwrench EV Cover Controller Advanced 80 Nm

Published: 2026-05-22

© 2026 Atlas Copco Industrial Technique AB | Legal Notice