Tools
Tools section describes how to setup the parameters (Tools and Inspections) necessary to do a test.
The device can store up to 10000 tools into its own memory. The Inspection gives the test type; the maximum number of Inspections per Tool is equal to 60.
Tap the Menu icon (
) in the Home page. Then select Tools.
The following is displayed:
A | Barcode button | B | Command button |
C | Play button | D | List of Tools |
E | Search button |
In each row, the following information about the tool are shown:
Name
Serial number
Tool type. The type is one of the following: click wrench, power tool, peak, pulse tool.
Torque range.
When enabled by external software, the Barcode button (
) allows to scan a barcode to search the corresponding Tool inspection(s) on the measuring device. If the search finds a single Tool inspection, it is automatically run; if the search finds multiple Tool inspections with the same barcode identifier, run the inspection of interest from the list.
Play (
) gets active only after adding Inspection(s) to the Tool. If enabled, tap Play to run the test.
