AluGuard Cover Kit
Attachments
Instruction Supplement
Compatible Tools
The AluGuard Cover Kit is only compatible to the following tools:
LSV38 SA12 125 (8423013113)
LSV38 ST12 125 (8423013109)
LSV39 SA12 125 (8423013301)
AluGuard Cover Kit
Contents

Part | Description |
|---|---|
A | Cover |
B | Flange nut |
C | Pin spanner |
D | Spacer |
The AluGuard cover kit does not include a cutting blade.
Make sure to use a 125 mm circular carbide-tipped cutter with blade thickness 2−4 mm.
Other types of cutting blades can cause loss of application control with lethal wounds or property damage as a result.
Regularly inspect the cutting blade for damage and cracking.
Blunt cutting blades will run hot. When blunt, resharpen the blade.
If damaged or cracked, replace the cutting blade with a new one.
For information regarding suitable cutting blades, visit: https://servaid.atlascopco.com.
Assembly Instructions
To assemble the AluGuard cover kit, do the following:
Before placing the cutting blade on the spindle, make sure that the blade rotates in the correct direction. Compare with the rotation direction shown on the tool.
Place the cutting blade on the spindle of the tool.
Place the spacer in the center of the blade. Make sure that blade and the spacer rotate freely and properly.
Place the cover over the cutting blade and spacer. Press the cover into the correct position making sure that the spacer remains centered.
Place the flange nut in the center of the cover and turn it clockwise.
Lock the flange nut clockwise with the pin spanner.
Before operating the tool, check that:
The protection guard is moving freely.
The guard is closing quickly when released.


Operating Instructions
To operate the tool, do the following:
Before starting the tool, hold it with a firm grip in the throttling hand.
Lift the AluGuard cover with the open support hand (A).
Lock the AluGuard cover in an open position by holding the tool support handle in a steady grip, while resting the AluGuard cover handle inside the hand (B).
Start the tool. Always use a proper two hand grip during operation and mind your balance.
Do not overheat the cutter during operation.
Position A
The AluGuard cover is in the closed safety position.
Position B
The AluGuard cover is in the open operating position.
