Isolated Quick Change Adapter

Attachments

Declarations

Standards

This product is evaluated to IEC/EN 60900 and ASTM F1505. Recommendation for use and in-service care as per Annex D, IEC 60900:2018.

Regional Requirements

WARNING

This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to

https://www.p65warnings.ca.gov/

Safety

DO NOT DISCARD - GIVE TO USER

WARNING

Read all safety warnings, instructions, illustrations and specifications provided with this power tool.

Failure to follow all instructions listed below may result in electric shock, fire, and/or serious injury.

Save all warnings and instructions for future reference.

WARNING

All locally legislated safety rules regarding installation, operation and maintenance shall be respected at all times.

Statement of Use

  • For professional use only.

  • This product and its accessories must not be modified in any way.

  • Do not use this product if it has been damaged.

  • If the product data or hazard warning signs on the product cease to be legible or become detached, replace without delay.

  • The product must only be installed, operated and serviced by qualified personnel in an industrial environment.

In this Section

Intended use

This product is intended for use on or in close proximity to energized electrical apparatus or conductors operating at maximum voltage of 1000 V.

Product Specific Instructions

General Installation Safety

WARNING

High Voltage Hazard

Accidental contact with any high voltage may result in severe injury or death.

  • Always use the isolated quick change adapter with adequate insulated socket covers and adequate Saltus ROTACTION sockets, bit sockets, extensions and bits or bits without ROTACTION.

  • Do not use sockets from other brands in combination with the isolated quick change adapter.

  • Do not use the isolated quick change adapter if it is damaged in any way or if it is not correctly installed.

  • Only the isolated parts of the quick change adapter are protected against high voltage.

Installation

For installation options, refer to the Installation Manual for Isolated Quick Change Adapters Instruction Supplement in ServAid.

General Operation Safety

Inspection Before Use

  • Visually inspect this product every time before use.

  • If there is any doubt concerning the safety of this product, a suitably trained person must examine it and retest it, if necessary.

Temperature

  • Use this product in an industrial environment with a regulated temperature.

General Service and Maintenance Safety

Storage

  • Store this product properly so as to minimize the risk of damage to the isolation due to storage or transportation.

  • Store this product separated from other tools to avoid mechanical damage or confusion.

  • Protect this product from excessive heat as well as from UV radiation.

Periodic Examination

A suitably trained person should perform an annual visual examination of this product to determine its suitability for further service.

Signs and Stickers

The product is fitted with signs and stickers containing important information about personal safety and product maintenance. The signs and stickers shall always be easy to read.