Route and install power- and control cables to FlexCarrier
Make sure that the cables are in good condition before connecting them to the system. Check that
Cables are not damaged
Connectors are not damaged.
If these conditions are not fulfilled the system must not be connected to mains or switched on.
Systems where damages to connections or cables are found must be disconnected and repaired immediately.
WARNING
It is dangerous to use systems, cables or units that are not in good condition or not connected according to electrical regulations and system requirements, whether manufactured by Atlas Copco or third party.
Install power cables.
WARNINGUse only Atlas Copco tool cables.
WARNINGDo not connect or disconnect power cables when the power is on. Always turn off the power to the system with the electrical mains.
WARNINGRisk of Injury When Handling Power Cable Latch
Fingers can be injured.
Open and close the latch with care.
Install control cables.
