Adjusting the wire length
Only applicable to WP models that have a wedge adjustment at the lower attachment point.
The balancer is delivered with a long wire so that the wire length can be adjusted to the on-site circumstances.
The minimum distance between the wire clamp and the wire wedge is 100 mm.
Remove the clamp from the wire wedge.
Adjust the wire length.
Make sure that the distance between the wire clamp and the wire wedge is no shorter than 100 mm.
Put the clamp back on the wire wedge.
Tighten the wire end with the supplied ferrule or a clamp in accordance with EN 13411-3:2022.
Cut the remaining wire end straight off.
