Joints
The set of parameters that controls a test process is within a joint. This section describes how to setup the joint parameters necessary to do a test.
The device can store up to 20000 joints into its own memory.
Tap the Menu icon in the Home page. Then, select Joints.
The following is displayed:
A | Barcode button | B | Command button |
C | Play button | D | List of Joint |
E | Search button |
In each row, the following information about the Joint are shown:
Name
Torque range
When enabled by external software, the Barcode button (
) allows to scan a barcode to search the corresponding Joint inspection(s) on the measuring device. If the search finds a single Joint inspection, it is automatically run; if the search finds multiple Joint inspections with the same barcode identifier, run the inspection of interest from the list.
Play (
) gets active only after adding Inspection(s) to the Joint. If enabled, tap Play to run the test.
